Thermador repair Laguna Hills
Thermador range repair: burners that won't light or keep clicking
Short answer: Thermador ranges and rangetops use the star-shaped Star burner with an electronic re-ignition system. A burner that keeps clicking is usually wet, has a misaligned cap, or a bad knob switch. A burner that never catches typically has clogged ports, a broken igniter or a tired spark module.
Why Thermador burners behave the way they do
The Star burner spreads flame across five points to give a wider flame pattern than a round burner, which also means more ports that can clog. Thermador's re-ignition feature watches for a flame and re-sparks if it goes out. That is helpful when a draft blows a simmering flame out, but it also means anything that interrupts flame sensing (moisture, a shifted cap, grease on the igniter) produces clicking that will not stop.
Many Thermador ranges also have an ExtraLow simmer feature that cycles the flame on and off at very low settings. Some owners mistake that cycling and its occasional click for a fault. If clicking only happens on the lowest simmer settings and the flame relights normally, it may be working as designed.
Diagnose by symptom
- All burners click when one knob is turned: normal while lighting. If it continues once the flame is lit, that burner's cap, igniter or flame sensing is the issue.
- Clicking with every knob off: a knob switch is stuck closed, usually from moisture or a spill that ran down the valve stem.
- One burner will not light but clicks: blocked ports near the igniter, a crooked cap, or a split igniter.
- No clicking at all: power to the spark module, the module itself, or the range is unplugged or on a tripped circuit.
- Yellow, lazy flame: clogged ports or a poor gas-air mix; leave that burner off.
Safe at-home steps
- Turn every knob off. If clicking continues, unplug the range or switch off its breaker.
- Remove grates, caps and burner bases. Wash in warm soapy water, then dry completely; overnight is ideal.
- Clear ports with a straight pin. Do not enlarge them.
- Reassemble so each cap sits level, with the notches aligned as shown in the manual.
- Restore power and test each burner on its own.
If you smell gas, turn everything off, avoid switches and flames, ventilate, and call the gas company from outside.
What a repair visit covers
A technician tests each knob switch for continuity, inspects igniters for cracks and carbon tracking, checks the spark module output and harness, and confirms flame quality on all burners. Laguna Hills has many homes where Thermador ranges were installed in remodels and have run for years, so harness wear under the cooktop and switch corrosion from cleaning sprays are common findings. Replacing only the failed component keeps cost down.
Oven igniters on Thermador gas ranges
The same visit often turns up an oven question. On all-gas Thermador ranges, the oven uses a glow-bar igniter rather than a spark. If the oven takes a long time to light or never lights while the cooktop works perfectly, the oven igniter has likely weakened. It is a separate part from the cooktop igniters, so mention both symptoms if you have them.
Cost factors
Switches and igniters are modest repairs. Spark modules and harnesses cost more. Ranges installed tightly between cabinets may need to be pulled forward, which adds time. Oven issues found during the same visit are quoted separately.
Quick answers
Why does my Thermador cooktop click on low simmer?
The ExtraLow feature cycles the flame, and the re-ignition system may spark briefly. Continuous clicking at other settings is not normal.
Is it safe to use a Thermador range that keeps clicking?
The clicking is not dangerous on its own, but turn off power if it will not stop, and never leave a burner on that is not lit.
To book, send your Thermador or Miele details from the contact page: brand, model, symptom and ZIP code.